enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RF power amplifier - Wikipedia

   en.wikipedia.org/wiki/RF_power_amplifier

   A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .

3. Radio receiver design - Wikipedia

   en.wikipedia.org/wiki/Radio_receiver_design

   The RF signal from the antenna may have one stage of amplification to improve the receiver's noise figure, although at lower frequencies this is typically omitted. The RF signal enters a mixer , along with the output of the local oscillator , in order to produce a so-called intermediate frequency (IF) signal.

4. Radio-frequency engineering - Wikipedia

   en.wikipedia.org/wiki/Radio-frequency_engineering

   Radio-frequency (RF) engineering is a subset of electrical engineering involving the application of transmission line, waveguide, antenna, radar, and electromagnetic field principles to the design and application of devices that produce or use signals within the radio band, the frequency range of about 20 kHz up to 300 GHz. [1] [2] [3]

5. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

6. Radio transmitter design - Wikipedia

   en.wikipedia.org/wiki/Radio_transmitter_design

   Typically a transmitter design includes generation of a carrier signal, which is normally [3] sinusoidal, optionally one or more frequency multiplication stages, a modulator, a power amplifier, and a filter and matching network to connect to an antenna. A very simple transmitter might contain only a continuously running oscillator coupled to ...

7. Radio receiver - Wikipedia

   en.wikipedia.org/wiki/Radio_receiver

   Commercial regenerative receiver from the early 1920s, the Paragon RA-10 (center) with separate 10R single tube RF amplifier (left) and three tube DA-2 detector and 2-stage audio amplifier unit (right). The 4 cylindrical dry cell "A" batteries (right rear) powered the tube filaments, while the 2 rectangular "B" batteries provided plate voltage.

8. Tuned radio frequency receiver - Wikipedia

   en.wikipedia.org/wiki/Tuned_radio_frequency_receiver

   A tuned radio frequency receiver (or TRF receiver) is a type of radio receiver that is composed of one or more tuned radio frequency (RF) amplifier stages followed by a detector (demodulator) circuit to extract the audio signal and usually an audio frequency amplifier. This type of receiver was popular in the 1920s.

9. Stub (electronics) - Wikipedia

   en.wikipedia.org/wiki/Stub_(electronics)

   Stubs are commonly used in antenna impedance matching circuits, frequency selective filters, and resonant circuits for UHF electronic oscillators and RF amplifiers. Stubs can be constructed with any type of transmission line: parallel conductor line (where they are called Lecher lines), coaxial cable, stripline, waveguide, and dielectric waveguide.