Search results
Results from the WOW.Com Content Network
A windpump replaced by a solar-powered pump at a water hole in the Augrabies Falls National Park. [Notes 1] This solar water pump up to 3.7 kW is useful for farmers.Solar-powered pumps run on electricity generated by photovoltaic (PV) panels or the radiated thermal energy available from collected sunlight as opposed to grid electricity- or diesel-run water pumps. [1]
NASA patented a type of solar-powered Stirling engine on August 3, 1976. It used solar energy to pump water from a river, lake, or stream. [1] The purpose of this apparatus is to “provide a low-cost, low-technology pump having particular utility in irrigation systems employed in underdeveloped arid regions of the earth…[using] the basic principles of the Stirling heat engine“.
This class of pump is often called a "hose pump". The biggest advantage with the hose pumps over the roller pumps is the high operating pressure of up to 16 bar. With rollers, max pressure can arrive up to 12 bar (170 psi) without any problem. If the high operating pressure is not required, a tubing pump is a better option than a hose pump if ...
The solenoid/diaphragm timer uses more battery power throughout the "on" cycle because the solenoid must be actuated the entire time that the water flow is "on". The ball valve timer using the motor and gear actuator only uses more battery power during the few seconds that motor is used to turn the water flow on or off.
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...
The device uses the water hammer effect to develop pressure that lifts a portion of the input water that powers the pump to a point higher than where the water started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower, and a need for pumping water to a destination higher in elevation than ...
A pump as turbine (PAT), also known as a pump in reverse, is an unconventional type of reaction water turbine, which behaves in a similar manner to that of a Francis turbine. The function of a PAT is comparable to that of any turbine , to convert kinetic and pressure energy of the fluid into mechanical energy of the runner.
Rope pump schematic. A rope pump is a type of pump of which the main or most visible component is a continuous piece of rope, in which the rope is integral in raising water from a well. Rope pumps are often used in developing areas, the most common design of which uses PVC pipe and a rope with flexible or rigid valves. Rope pumps are cheap to ...