Search results
Results from the WOW.Com Content Network
Work Completed: Replaced gear knob, passenger door and door mirrors, pulled and filled dent in rear nearside quarter panel, repainted wheels and replaced the centre caps, applied new door sill decals, replaced handbrake lever, replaced handbrake warning light, adjusted rear exhaust section to prevent it from knocking against the undercarriage, fitted a new stereo, engine service including ...
When equipped with the 289 "HiPo" engine and a 4.11 rear axle ratio, the 1965 Mustang achieved 0–60 mph (0–97 km/h) in 5.2 seconds and a 1 ⁄ 4 mile (402 m) time of 14.0 seconds at 100 mph (161 km/h). [34] The 1966 Mustang debuted with moderate trim changes including a new grille, side ornamentation, wheel covers, and gas cap.
The Ford 9-inch is an automobile axle manufactured by Ford Motor Company.It is known as one of the most popular axles in automotive history. It was introduced in 1957 model year cars and ended production in 1986, having been phased out in favor of the Ford 8.8 inch axle.
From 1965 until 2004, the Mustang shared chassis commonality with other Ford model lines, staying rear-wheel-drive throughout its production. From 1965 to 1973, the Mustang was derived from the 1960 Ford Falcon compact. From 1974 until 1978, the Mustang (denoted Mustang II) was a longer-wheelbase version of the Ford Pinto.
The 1965 GT350 had a full-size spare tire mounted in place of rear seats, making it a 2-seat-only vehicle (to qualify as a "sports car" under SCCA regulations), and rode on either silver-painted steel wheels or special cast-magnesium center "Cragar Shelby" 15-inch rims with chromed center caps marked with a stylized "CS". Total 1965 model year ...
The rear axle was a Ford 9-inch axle, with Hotchkiss drive and leaf springs; the front axle was a Dana 30, replaced by a Dana 44 in 1971. [11] In contrast to the Twin I-Beams of larger Ford trucks, the Bronco used radius arms to locate the coil-sprung front axle, along with a lateral track bar, allowing for a 34-foot turning circle, long wheel ...
The axle shafts and differential were changed from 28 splines in 1999 to 31 splines in 2001. [20] The rear decklid spoiler was redesigned. [20] The 1999 two-piece audio unit consisting of a radio with a tape deck and a separate single-CD player was upgraded to a larger, single-face, 6-disc unit in 2001. [20] The center console and trim were ...
Dubbed the E-Super Duty (in line with the F-Super Duty sold at the same time), this version was created using heavier-duty components than the existing Econoline 350 commercial models, such as a Dana 80 rear axle with higher 4.63 axle ratios, new parking brake assembly, and heavier-duty shocks to allow for a maximum GVWR of 16,000 lbs. It was ...