enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Sloan Valve Company - Wikipedia

   en.wikipedia.org/wiki/Sloan_Valve_Company

   The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907. Sales improved dramatically in 1908, to 150 ...

3. William Elvis Sloan - Wikipedia

   en.wikipedia.org/wiki/William_Elvis_Sloan

   William Elvis Sloan I (October 1867 – June 25, 1961) invented the Flushometer flushing mechanism for toilets and urinals. It is installed in millions of commercial, institutional and industrial restrooms worldwide.

4. Flushometer - Wikipedia

   en.wikipedia.org/wiki/Flushometer

   The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down. A groove in this cylinder allows water from the main supply to flow through when it is in a mid position. The valve is shut off at both its top and bottom positions.

5. Electric arc furnace - Wikipedia

   en.wikipedia.org/wiki/Electric_arc_furnace

   An electric arc furnace (EAF) is a furnace that heats material by means of an electric arc. Industrial arc furnaces range in size from small units of approximately one-tonne capacity (used in foundries for producing cast iron products) up to about 400-tonne units used for secondary steelmaking .

6. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   Faucets that meet energy efficiency standards for WaterSense mustn’t use more than 1.5 gpm, a 32% decrease in flow rate over the federal requirement. [10] Reduced flow faucets often make use of flow restrictors or faucet aerators to reduce the flowrate of the water. Using a faucet with an aerator results in an average 42% reduction in water ...

7. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   British Standard Pipe (BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external thread with an internal (female) thread.