Search results
Results from the WOW.Com Content Network
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
This runs on a general-purpose personal computer, and is designed to create and/or format labels for printing. The software can use native OS printer drivers, or embed drivers in the software, bypassing the OS print subsystem. It may work with dedicated label printers as described in this article, or use sheet- or continuous-fed labels in a ...
Printer cable refers to the cable that carries data between a computer and a printer. There are many different types of cables, for example: Serial: RS-232, EIA-422; Parallel; FireWire; USB; Parallel port printers have been slowly phased out, and are now difficult to find for the most part, being considered as an obsolete legacy port on most ...
The principle is the same for practically all card printers: the plastic card is passed through a thermal print head at the same time as a color ribbon. The color from the ribbon is transferred onto the card through the heat given out from the print head. The standard performance for card printing is 300 dpi (300 dots per inch, equivalent to 11 ...
A ribbon cable is a cable with many conducting wires running parallel to each other on the same flat plane. As a result, the cable is wide and flat. Its name comes from its resemblance to a piece of ribbon. [1] Ribbon cables are usually seen for internal peripherals in computers, such as hard drives, CD drives and floppy drives.
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
A 1997 update standardized the printer status codes. In 2000, the EPP and ECP modes were moved into the standard, as well as several connector and cable styles, and a method for daisy chaining up to eight devices from a single port. [9] Some host systems or print servers may use a strobe signal with a relatively low voltage output or a fast toggle.
During crimping, the extended end of this insulating sleeve is simultaneously pressed around the insulated area of the cable, creating strain relief. The insulating sleeve of insulated connectors has a color that indicates the wire's cross-section area. Colors are standardized according to DIN 46245: Red for cross-section areas from 0.5 to 1 mm²