Ad
related to: motorola accessory pinout replacement costzoro.com has been visited by 1M+ users in the past month
Average: 4.7 out of 5 - 83,309 reviews - Power Reviews
Search results
Results from the WOW.Com Content Network
A Motorola connector (also called a Motorola antenna plug [citation needed] or a male DIN 41585 [1]) is a common coaxial cable RF connector used primarily in the automotive industry for connecting the coaxial feedline from the antenna to the radio receiver. It is also sometimes used for connecting scanner antennas to scanners.
The Motorola MC68010 and Motorola MC68012 are 16/32-bit microprocessors from Motorola, released in 1982 as successors to the Motorola 68000. [3] The 68010 and 68012 added virtualization features, optimized loops and fixed several small flaws to the 68000.
In the early 1990s Motorola produced an evaluation board kit for the 68HC11 with several UARTs, RAM, and an EPROM. The cost of the evaluation kit was $68.11. [5] The standard monitor for the HC11 family is called BUFFALO, "Bit User Fast Friendly Aid to Logical Operation".
A 2N3904 made by Motorola.The pinout from left to right is: Emitter, Base, Collector. [1] A 2N3904 (lower left) in a TO-92 package on a breadboard. The 2N3904 is a common NPN bipolar junction transistor used for general-purpose low-power amplifying or switching applications.
Motorola claimed in some marketing literature that it executes some instructions 40% faster than a 68881 at the same clock speed, though this did not reflect typical performance, as seen by its more modest improvement in the table below. The 68882 is pin compatible with the 68881 and can be used as a direct replacement in most systems.
To support lower-cost systems and control applications with smaller memory sizes, Motorola introduced the 8-bit compatible MC68008, also in 1982. This is a 68000 with an 8-bit data bus and a smaller (20-bit) address bus. After 1982, Motorola devoted more attention to the 68020 and 88000 projects.
The Motorola 68000 series (also known as 680x0, m68000, m68k, or 68k) is a family of 32-bit complex instruction set computer (CISC) microprocessors. During the 1980s and early 1990s, they were popular in personal computers and workstations and were the primary competitors of Intel 's x86 microprocessors.
The ICU was conceived by Vern Gregory in the mid-1970s while working as an engineer in a marketing / applications group of Motorola Semiconductor Products Sector in Phoenix, Arizona, USA; Brian Dellande originated circuit and sub-routine designs, and co-wrote the manual; Ray DiSilvestro was the bench technician; Terry Malarkey provided management support.
Ad
related to: motorola accessory pinout replacement costzoro.com has been visited by 1M+ users in the past month
Average: 4.7 out of 5 - 83,309 reviews - Power Reviews