Search results
Results from the WOW.Com Content Network
Representative schematic of a current-feedback op-amp or amplifier. The current-feedback operational amplifier ( CFOA or CFA ) is a type of electronic amplifier whose inverting input is sensitive to current , rather than to voltage as in a conventional voltage-feedback operational amplifier (VFA).
Block diagram of the CDBA. A current differencing buffered amplifier (CDBA) is a multi-terminal active component with two inputs and two outputs and developed by Cevdet Acar and Serdar Özoğuz. Its block diagram can be seen from the figure. It is derived from the current feedback amplifier (CFA).
The system (diagram right) is a feedback control system in which a feedback signal from a sensor representing the current position of the gun is compared with the control signal which represents the desired position, and the difference is amplified by the amplidyne generator to turn the gun mount motor. The components are:
Tustin has shown that the input and output power are the same, and so the machine transforms the constant-voltage input into a constant-current output. As with the metadyne generator, the Metadyne transformer can be partially compensated, and will continue to operate as a constant-current device until the compensation exceeds 97 per cent.
A block diagram of an electronic amplifier with feedback. A block diagram of an electronic amplifier with negative feedback is shown at right. The input signal is applied to the amplifier with open-loop gain A and amplified. The output of the amplifier is applied to a feedback network with gain β, and subtracted from the input to the amplifier ...
The Norton amplifier can be regarded as the dual of the operational transconductance amplifier (OTA) which takes a differential voltage input and provides a high impedance current output. The OTA has a gain measured in units of transconductance ( siemens ) whereas the Norton amplifier has a gain measured in units of transimpedance ( ohms ).
Current events; Random article; ... A common application is in feedback unidirectional voltage control circuits, where the sampled output voltage of the circuit under ...
The mirrored current is a precise copy of the input current. It may be used as a Wilson current source by applying a constant bias current to the input branch as in Fig. 2. The circuit is named after George R. Wilson, an integrated circuit design engineer who worked for Tektronix.