Search results
Results from the WOW.Com Content Network
The pour plate technique is the typical technique used to prepare plate count agars. Here, the inoculum is added to the molten agar before pouring the plate. The molten agar is cooled to about 45 degrees Celsius and is poured using a sterile method into a petri dish containing a specific diluted sample.
The CFU/plate is read from a plate in the linear range, and then the CFU/g (or CFU/mL) of the original is deduced mathematically, factoring in the amount plated and its dilution factor. A solution of bacteria at an unknown concentration is often serially diluted in order to obtain at least one plate with a countable number of bacteria.
The Miles and Misra Method (or surface viable count) is a technique used in Microbiology to determine the number of colony forming units in a bacterial suspension or homogenate.
The Wilhelmy plate consists of a thin plate usually on the order of a few square centimeters in area. The plate is often made from filter paper, glass or platinum which may be roughened to ensure complete wetting. In fact, the results of the experiment do not depend on the material used, as long as the material is wetted by the liquid. [1]
The phage can then be isolated from the resulting plaques in a lawn of bacteria on a plate. Viral cultures are obtained from their appropriate eukaryotic host cells. The streak plate method is a way to physically separate the microbial population, and is done by spreading the inoculate back and forth with an inoculating loop over the solid agar ...
Fractionation at total reflux. The Fenske equation in continuous fractional distillation is an equation used for calculating the minimum number of theoretical plates required for the separation of a binary feed stream by a fractionation column that is being operated at total reflux (i.e., which means that no overhead product distillate is being withdrawn from the column).
The inoculation loop is then dragged across the surface of the agar back and forth in a zigzag motion until approximately 30% of the plate has been covered. The loop then is re-sterilized and the plate is turned 90 degrees. Starting in the previously streaked section, the loop is dragged through it two to three times continuing the zigzag pattern.
The sample is then cooled and inspected for pour point as per the usual pour point method. The method usually gives higher pour point because the thermal history has not been cancelled by a prolonged thermal treatment. The lower pour point is measured by first pouring the sample into a stainless steel pressure vessel. The vessel is then screwed ...