enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   Similarly, M10 (10 mm nominal outer diameter) as per ISO 261 has a coarse thread version at 1.5 mm pitch and a fine thread version at 1.25 mm pitch. The term coarse here does not mean lower quality, nor does the term fine imply higher quality. The terms when used in reference to screw thread pitch have nothing to do with the tolerances used ...

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Concrete screws are commonly blue in color, with or without corrosion coating. They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm).

4. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   5 ⁄ 16: 8.0 7 ⁄ 16: 11.113 14: 1.814 ... based standard that uses a 47.5° thread angle and has its own ... to 1955 were built using metric threads with bolt ...

5. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

6. Trapezoidal thread form - Wikipedia

   en.wikipedia.org/wiki/Trapezoidal_thread_form

   This thread form also allows for the use of a split nut, which can compensate for nut wear. [8] The line of General Purpose (GP) Acme threads (ASME/ANSI B1.5-1997) are not designed to sustain external radial loads and both the nut and bolt are, ideally, independently supported (the nut by a linear guide and the screw by shaft bearings).

7. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   V Thread Form: 1 ⁄ 4 ″-20 UNC #4-40 UNC ASME B1.5-1997 (R2014) Acme Screw Threads: Trapezoidal Thread Form: Tr 60×9 ANSI/ASME B1.9-1973 (R2017) Buttress Inch Screw Threads: Breech-Lock Thread Form: ASME B1.10M-2004 (R2014) Unified Miniature Screw Threads: V Thread Form: 0.60 UNM ANSI/ASME B1.11-1958 (R2016) Microscope Objective Thread: V ...