Ads
related to: arduino pull resistor value
Search results
Results from the WOW.Com Content Network
In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1] It is typically used in combination with components such as switches and transistors , which physically interrupt the connection of subsequent components to ground or to V CC .
The output is usually connected to an external pull-up resistor, which pulls the output voltage to the resistor's supply voltage when the transistor is off. For PNP open collector outputs, the emitter of the PNP transistor is internally connected to the positive voltage rail , so the collector outputs a high voltage when the transistor is on or ...
Pull-up resistors are provided by the I3C controller. External pull-up resistors are no longer needed. Clock Stretching – devices are expected to be fast enough to operate at bus speed. The I3C controller is the sole clock source. I²C Extended (10-bit) Addresses. All devices on an I3C bus are addressed by a 7-bit address.
Sets the output value on pins configured as outputs. Enables or disables the pull-up resistor on pins configured as inputs. PINx: Input register, used to read an input signal. On some devices, this register can be used for pin toggling: writing a logic one to a PINx bit toggles the corresponding bit in PORTx, irrespective of the setting of the ...
The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2010. [2] [3] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards (shields) and other circuits. [1]
For example, 8K2 indicates a resistor value of 8.2 kΩ. Additional zeros imply tighter tolerance, for example 15M0. When the value can be expressed without the need for a prefix, an "R" or "F" is used instead of the decimal separator. For example, 1R2 indicates 1.2 Ω, and 18R indicates 18 Ω.
The following historical mnemonics are generally considered offensive/outdated and should not be used in current electronics training: Bad boys rape our young girls but Violet gives willingly.
A 2.26 kΩ, 1%-precision resistor with 5 color bands (), from top, 2-2-6-1-1; the last two brown bands indicate the multiplier (×10) and the tolerance (1%).. An electronic color code or electronic colour code (see spelling differences) is used to indicate the values or ratings of electronic components, usually for resistors, but also for capacitors, inductors, diodes and others.
Ads
related to: arduino pull resistor value