Search results
Results from the WOW.Com Content Network
The cable used to connect the MIL-STD-1553 bus and stub devices has a characteristic impedance of 78 ohms at 1 MHz. A 2-conductor twisted-pair cable known as twinax is used to connect the bus and stub devices. The insulated pairs are balanced and have an overall shielding braid around the pairs.
Twisted pair cabling is a type of communications cable in which two conductors of a single circuit are twisted together for the purposes of improving electromagnetic compatibility. Compared to a single conductor or an untwisted balanced pair , a twisted pair reduces electromagnetic radiation from the pair and crosstalk between neighboring pairs ...
If a new pair of impedance and admittance is added in front of the network, its input impedance remains unchanged since the network is infinite. Thus, it can be reduced to a finite network with one series impedance Z {\displaystyle \ Z\ } and two parallel impedances 1 / Y {\displaystyle \ 1/Y\ } and Z IT . {\displaystyle \ Z_{\text{IT}}~.}
When used in relation to communications wiring, RS-422 wiring refers to cable made of 2 sets of twisted pair, often with each pair being shielded, and a ground wire. While a double-pair cable may be practical for many RS-422 applications, the RS-422 specification only defines one signal path and does not assign any function to it.
Low frequency applications, such as twisted pair telephone lines, are dominated by R and C only. High frequency applications, such as RF co-axial cable , are dominated by L and C . Lines loaded to prevent distortion need all four elements in the analysis, but have a simple, elegant solution.
The nominal impedance of the transmission line and of the amplifiers and equalisers in the transmission chain will all be the same value. [6] Nominal impedance is used, however, to characterise the transducers of an audio system, such as its microphones and loudspeakers. It is important that these are connected to a circuit capable of dealing ...
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
The greater the variation in impedance, the greater the return loss reading. If three pairs of wire pass by a substantial amount, but the fourth pair barely passes, it usually is an indication of a bad crimp or bad connection at the RJ45 plug. Return loss is usually not significant in the loss of a signal, but rather signal jitter.