Search results
Results from the WOW.Com Content Network
JTAG (named after the Joint Test Action Group which codified it) is an industry standard for verifying designs of and testing printed circuit boards after manufacture.. JTAG implements standards for on-chip instrumentation in electronic design automation (EDA) as a complementary tool to digital simulation. [1]
Physically, IEEE-ISTO 5001-2003 defines a standard set of connectors for connecting the debug tool to the target or system under test. Logically, data is transferred using a packet-based protocol. This protocol can be JTAG (IEEE 1149.1); or, for high-speed systems, an auxiliary port can be used that supports full duplex, higher bandwidth transfers.
MIPI Alliance Debug Architecture provides a standardized infrastructure for debugging deeply embedded systems in the mobile and mobile-influenced space. The MIPI Alliance MIPI Debug Working Group has released a portfolio of specifications; their objective is to provide standard debug protocols and standard interfaces from a system on a chip (SoC) to the debug tool.
During the pre-silicon process, engineers test devices in a virtual environment with sophisticated simulation, emulation, and formal verification tools. In contrast, post-silicon validation tests occur on actual devices running at-speed in commercial, real-world system boards using logic analyzer and assertion-based tools.
Cleared to 0 by the processor for debug exceptions inside RTM transactions, [f] set to 1 for all debug exceptions outside transactions. On processors without TSX, bit 16 of DR6 is a read-only bit, acting in the same way as bits 31:17. 31:17 — Reserved. Read as all-0s on 386/486/6x86 processors, all-1s on later processors. 63:32 — (x86-64 ...
Dolph Lundgren is officially cancer-free after undergoing his last procedure.. The Swedish actor, 67, who was diagnosed with kidney cancer in 2015, posted a video on Instagram and gave a health ...
A debug port is a diagnostic interface (akin to a computer port) included in an electronic system or integrated circuit to aid design, fabrication, development, bootstrapping, configuration, debugging, and post-sale in-system programming. In general terms, a debug port is not necessary for end-use function and is often hidden or disabled in ...
The setp.cc.type instruction sets a predicate register to the result of comparing two registers of appropriate type, there is also a set instruction, where set.le.u32.u64 %r101, %rd12, %rd28 sets the 32-bit register %r101 to 0xffffffff if the 64-bit register %rd12 is less than or equal to the 64-bit register %rd28.