Search results
Results from the WOW.Com Content Network
Tying the adjustable grip hitch (slipped) The working end is wrapped inwards around the standing part (A-B) twice (1). Then another turn is made around both parts and a bight is pulled through the last wrap (2, 3) for the slipped version (left image), or just the end for the non-slipped version (right image).
The taut-line hitch is an adjustable loop knot for use on lines under tension. It is useful when the length of a line will need to be periodically adjusted in order to maintain tension. It is made by tying a rolling hitch around the standing part after passing around an anchor object. Tension is maintained by sliding the hitch to adjust the ...
The Arbor knot is a typical fishers' knot.Its primary use is to attach fishing line to the arbor of a fishing reel.. It has also gained popularity (often under the name "Canadian Jam Knot" or nicknamed "bushcraft zip tie") as a general binding knot to tie down a roll of e.g. a sleeping bag, or to begin a lashing.
The knot provides a compact, streamlined and decorative way of joining two ropes. However its primary attribute is that it is resistant against working loose when subject to intermittent loads. [1] The security of the knot arises from the fact that at step 3 in the tying sequence the knot is a Double Harness Bend with parallel ends (ABoK #1421 ...
The following three-step process for tying the two half-hitches is also explained in the image gallery below. Click on the images for high-resolution versions. Begin by forming a clockwise loop around the pole, with the working end of the rope on top. Bring the working end through the loop. At this point, you have an overhand knot around the pole.
The double bowline is one of the typical tie-in knots used in climbing, along with the figure eight follow through [3] [4] and the Yosemite bowline. [5] The advantage of the double bowline over the figure 8 is that it is easier to untie after being weighted in a fall, [3] [4] and so is used by sport climbers who take multiple lead falls and then have trouble untying their figure eights.
As mentioned earlier, this knot can replace the figure-eight knot when tying into a climbing harness by tying a regular bowline knot and then re-threading it, such as is done with a figure eight knot. However, it is critical to use a strong backup knot with plenty of tail beyond the knot, as the knot may untie during long climbs. The advantage ...
The instructions on how to create a slippery eight loop is as follows: Begin by creating a figure eight knot with one end long enough to be looped through it again; Make sure that the figure eight loop is not tight, but rather quite loose with obvious gaps; Bring the long, working end to the top of the knot