Search results
Results from the WOW.Com Content Network
High radon levels in a Minnesota (USA) basement with a passive under slab vent pipe system can be seen in the left half of the graph. After installation of a radon fan (ASD), a permanent reduction in radon levels to approximately 0.6 pCi/L can be seen in the right half of the graph. The most common approach is active soil depressurization (ASD).
Very high humidity levels can allow mold or mildew growth, associated with a musty smell and potentially with health problems. The below-ground orientation of many earth-sheltered homes can allow accumulation of radon gas (which is known to increase the risk of lung cancer) or other undesirable materials (e.g. off gassing from construction ...
Radon is measured in picocuries per liter of air (pCi/L) or becquerel per cubic meter (Bq m-3). Both are measurements of radioactivity. The World Health Organization (WHO) sets the ideal indoor radon levels at 100 Bq/m-3. [97] In the United States, it is recommend to fix homes with radon levels at or above 4 pCi/L.
Under this modeling, the best policy is obviously to reduce the radon levels of all homes where the radon level is above average, because this leads to a significant decrease of radon exposure on a significant fraction of the population; but this effect is predicted in the 0–200 Bq/m 3 range, where the linear model has its maximum uncertainty ...
In a working mine, the radon level can be controlled by ventilation, sealing off old workings and controlling the water in the mine. The level in a mine can go up when a mine is abandoned; it can reach a level which can cause the skin to become red (a mild radiation burn). The radon levels in some of the mines can reach 400 to 700 kBq m −3. [17]
It was determined that radon levels in his home's basement were in excess of 100,000 Bq/m 3 (2.7 nCi/L); he was told that living in the home was the equivalent of smoking 135 packs of cigarettes a day, and he and his family had increased their risk of developing lung cancer by 13 or 14 percent. [88]
The high point of the vent system (the top of its "soil stack") must be open to the exterior at atmospheric pressure. On large systems, separate parallel vent stacks may also be run to ensure sufficient airflow, because the number of devices linked to an atmospheric vent, and their distances from it, are regulated by plumbing code.
A real-valued Radon measure is defined to be any continuous linear form on K (X); they are precisely the differences of two Radon measures. This gives an identification of real-valued Radon measures with the dual space of the locally convex space K (X). These real-valued Radon measures need not be signed measures.