enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Blowout (tire) - Wikipedia

    en.wikipedia.org/wiki/Blowout_(tire)

    Automobile tire damaged after an impact. A blowout (also known as a burst) is a rapid, explosive loss of inflation pressure of a pneumatic tire.. The primary cause for a blowout is encountering an object that cuts or tears the structural components of the tire to the point where the structure is incapable of containing the compressed air, with the escaping air adding to further tear through ...

  3. Tire load sensitivity - Wikipedia

    en.wikipedia.org/wiki/Tire_load_sensitivity

    Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increases.

  4. SAE J2452 - Wikipedia

    en.wikipedia.org/wiki/SAE_J2452

    SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...

  5. Tire code - Wikipedia

    en.wikipedia.org/wiki/Tire_code

    Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.

  6. Tire uniformity - Wikipedia

    en.wikipedia.org/wiki/Tire_uniformity

    Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...

  7. Southwest Airlines plane blew tire during take off, made ...

    www.aol.com/southwest-air-plane-blows-tire...

    According to the online site Flight Aware, which tracks flight paths, the Boeing 737-800 took off at 6:31 p.m., was diverted and then returned to the Denver airport 41 minutes later.. No injuries ...

  8. European Tyre and Rim Technical Organisation - Wikipedia

    en.wikipedia.org/wiki/European_Tyre_and_Rim...

    The European Tyre and Rim Technical Organisation (ETRTO) exists to specify and harmonise sizes of rims and their associated pneumatic tyres across the European Union.ETRTO sizes apply to rims and tyres for vehicles of all types, including bicycles.

  9. Cold inflation pressure - Wikipedia

    en.wikipedia.org/wiki/Cold_inflation_pressure

    Cold inflation pressure is the inflation pressure of tires as measured before a car is driven and the tires warmed up. Recommended cold inflation pressure is displayed in the owner's manual and on the Tire Information Placard attached to the vehicle door edge , pillar , glovebox door or fuel filler flap .