enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Rake angle - Wikipedia

    en.wikipedia.org/wiki/Rake_angle

    In machining, the rake angle is a parameter used in various cutting processes, describing the angle of the cutting face relative to the workpiece. There are three types of rake angles: positive, zero or neutral, and negative. Positive rake: A tool has a positive rake when the face of the cutting tool slopes away from the cutting edge at inner side.

  3. Try square - Wikipedia

    en.wikipedia.org/wiki/Try_square

    A try square or try-square is a woodworking tool used for marking and checking 90° angles on pieces of wood. Though woodworkers use many different types of square, the try square is considered one of the essential tools for woodworking. [1] The square in the name refers to the 90° angle.

  4. Rift sawing - Wikipedia

    en.wikipedia.org/wiki/Rift_sawing

    Diagonal- and stepped-cut rift-sawing is intermediate to flat-sawn and radial cut lumber. The angle of the bastard grain may differ along the width of the board or between opposing sides, and enhances the appearance of ray fleck. Flat-sawing is the quickest method, producing the least wood waste and largest possible boards from a log.

  5. Quarter sawing - Wikipedia

    en.wikipedia.org/wiki/Quarter_sawing

    Riftsawn wood has every board cut along a radius of the original log, so each board has a perpendicular grain, with the growth rings oriented at right angles to the surface of the board. However, since this produces a great deal of waste (in the form of wedge-shaped scraps from between the boards) rift-sawing is very seldom used.

  6. Miter joint - Wikipedia

    en.wikipedia.org/wiki/Miter_joint

    90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.

  7. Square (tool) - Wikipedia

    en.wikipedia.org/wiki/Square_(tool)

    Made with a thin steel blade fixed at 90° into a thicker stock that is typically made of wood. The inside face of the stock is sometimes faced with brass to reduce wear. Historically woodworkers would often make their own try squares out of wood. The top of the stock is sometimes at a 45° angle so the square can also be used as a mitre square.

  8. Ripsaw - Wikipedia

    en.wikipedia.org/wiki/Ripsaw

    With the "rip" tooth pattern, the edges are sharpened at right angles to the cutting plane, forming chisel-like cutting surfaces, whereas crosscut teeth are sharpened at an angle, so that each tooth has a knife-like cutting point in contact with the wood. [1]

  9. Saw - Wikipedia

    en.wikipedia.org/wiki/Saw

    In woodworking, a cut made at (or close to) a right angle to the direction of the wood grain of the workpiece. A crosscut saw is used to make this type of cut. Rip cut In woodworking, a cut made parallel to the direction of the grain of the workpiece. A ripsaw is used to make this type of cut. Plytooth blade