Ad
related to: splice kit approved for walls construction
Search results
Results from the WOW.Com Content Network
Splice with more modern power outlet, a probable code violation as seen here Wiring running through tubes, and turning a corner supported by a knob. Notice the direct splice with more modern (1950s-era) non-metallic–sheathed cable .
A splice joint is a method of joining two members end to end in woodworking. [1] The splice joint is used when the material being joined is not available in the length required. It is an alternative to other joints such as the butt joint and the scarf joint. Splice joints are stronger than unreinenforced butt joints and have the potential to be ...
In structural engineering and construction, a gusset plate is a plate for connecting beams and girders to columns. A gusset plate can be fastened to a permanent member either by bolts, rivets or welding or a combination of the three. [1] They are used in bridges and buildings, as well as other structures. [1]
Although there are many types of anchors or anchorages, according to the Dictionary of Architecture and Construction, an anchor plate specifically is a "wrought-iron clamp, of Flemish origin, on the exterior side of a brick building wall that is connected to the opposite wall by a steel tie-rod to prevent the two walls from spreading apart ...
PBS's television series This Old House utilized Superior Walls products for their Carlisle Project in 2005, [18] Weston Project in 2008, [19] and the Jamestown House in 2018. [20] DIY Network's television series Blog Cabin featured Superior Walls during the 2008 season for work on a cabin in Tennessee. [21]
A mechanical splice is a junction of two or more optical fibers that are aligned and held in place by a self-contained assembly (usually the size of a large carpenter's nail). [1] The fibers are not permanently joined, just precisely held together so that light can pass from one to another.
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.
Ad
related to: splice kit approved for walls construction