Ads
related to: what mhz does at&t use for phone internet signal repeater
Search results
Results from the WOW.Com Content Network
Amateur repeaters in the 144–148 MHz band usually use a 600 kHz (0.6 MHz) separation, in the 1.25-meter band use a 1.6 MHz separation, in the 420–450 MHz band use a 5 MHz separation, and in the 902–928 MHz band use a 25 MHz separation. Systems in the 450–470 MHz band use a 5 MHz separation with the input on the higher frequency.
The 1850–1990 MHz PCS band is divided into six frequency blocks (A through F). Each block is between 10 MHz and 30 MHz in bandwidth. License (A or B) is granted for Major Trading Areas (MTAs). License (C to F) is granted for Basic Trading Areas (BTAs). License (G), where issued, is granted for Economic Areas (EAs).
A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.
Many GSM phones support three bands (900/1,800/1,900 MHz or 850/1,800/1,900 MHz) or four bands (850/900/1,800/1,900 MHz), and are usually referred to as tri-band and quad-band phones, or world phones; with such a phone one can travel internationally and use the same handset. This portability is not as extensive with IS-95 phones, however, as IS ...
In such a system, when one repeater is keyed-up by receiving a signal, all the other repeaters in the network are also activated and will transmit the same signal. The connections between the repeaters are made via radio (usually on a different frequency from the published transmitting frequency) for maximum reliability.
AT&T (NYS: T) estimates that it will cost $1 billion to $2 billion to integrate Qualcomm's (NAS: QCOM) Lower D and E Block 700 MHz spectrum into its network, according to the filing with the FCC.
A mobile phone signal (also known as reception and service) is the signal strength (measured in dBm) received by a mobile phone from a cellular network (on the downlink). Depending on various factors, such as proximity to a tower , any obstructions such as buildings or trees, etc. this signal strength will vary.
Apart from their main spectrum holdings across large regions in the country (listed below) the major US carriers (AT&T, Sprint, T-Mobile & Verizon) also hold various Cellular Market Area (CMA) and/or Economic Area (EA) licenses for the AWS 1700 band, as well as Major Trading Area (MTA) and/or Basic Trading Area (BTA) licenses for the PCS 1900 band.
Ads
related to: what mhz does at&t use for phone internet signal repeater