enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

3. Milwaukee Tool - Wikipedia

   en.wikipedia.org/wiki/Milwaukee_Tool

   By 1935, Milwaukee Electric Tool Corporation developed a lightweight 3/4" electric hammer drill. This power tool was designed to drill and sink anchors into concrete. This drill could also be converted into a standard 3/4" drill. Milwaukee also designed an easy-to-handle, single-horsepower sander/grinder that weighed only 15 pounds. [7]

4. High-speed steel - Wikipedia

   en.wikipedia.org/wiki/High-speed_steel

   High-speed steel (HSS or HS) is a subset of tool steels, ... It is usually used to manufacture a variety of tools, such as drill bits, taps and reamers. 1.3343 is the ...

5. Drilling - Wikipedia

   en.wikipedia.org/wiki/Drilling

   Peck drilling involves plunging the drill part way through the workpiece, no more than five times the diameter of the drill, and then retracting it to the surface. This is repeated until the hole is finished. A modified form of this process, called high speed peck drilling or chip breaking, only retracts the drill slightly. This process is ...

6. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   The cost of a core drill is high compared to a twist drill, but the cost per hole made with the core drill is less as compared to twist drills, this is because a single core drill makes 5 to 10 times more holes than a twist drill. [9] Annular cutters are more fragile than a drill bits of the same diameter and may thus shatter more easily.

7. Glass cutter - Wikipedia

   en.wikipedia.org/wiki/Glass_cutter

   Pressure as light as 5 or 6 pounds, upon a 120 to 140 degree wheel on thin glass; Pressure as heavy as 20+ pounds, with a 154 to 160 degree wheel, on very thick glass. The well-scored pane is ready to be split. The glass may be further weakened by lightly tapping along the cut. The glass cutter in the photo has a ball on one end for tapping the ...