Search results
Results from the WOW.Com Content Network
A number of units of measurement were used in the Philippines to measure various quantities including mass, area, and capacity. The metric system has been compulsory in the country since 1860, during the late Spanish colonial period. [1] A mixture of Spanish units and indigenous units were used alongside American units in the 1900s.
The next set of 3 digits gives the steel's minimum yield strength. So S355 has a minimum yield strength of 355 MPa for the smallest thickness range covered by the relevant standard – i.e. EN10025. [2] Below is a table indicating the most common application codes.
Steel structures – Part 4: Analysis of safety against buckling of shells: Withdrawn: DIN EN 1993: DIN 18800-5: Steel structures – Part 5: Composite structures of steel and concrete – Design and construction: Withdrawn: DIN EN 1994: DIN 18800-7: Steel structures – Part 7: Execution and constructor's qualification: Active: EN 1090-2
In June 2013, ASME replaced Fed Spec GGG-P-463C with the American National Standard (ANS) ASME B89.3.7 – 2013 Granite Surface Plates. [7] Iso standard defines ISO8512-2 for granite surface plates, but it seems the current in use is still dating back 1990. [8]
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]
The progression of thicknesses is clear in column 3 (U.S. standard for sheet and plate iron and steel 64ths inch (delta)). The thicknesses vary first by 1 ⁄ 32 inch in higher thicknesses and then step down to increments of 1 ⁄ 64 inch, then 1 ⁄ 128 inch, with the final increments at decimal fractions of 1 ⁄ 64 inch.
There are four types of materials available: O-1 tool steel, A-2 tool steel, A-6 tool steel, and 1018 steel (low-carbon or low-carb steel). Lengths are either 18 or 36 in (457 or 914 mm) long, various widths up to 16 in (406 mm) are available, and thicknesses range from 1 ⁄ 64 to 2.875 in (0.40 to 73.03 mm).
In the case of steel products such as sections, bolts and fabricated steelwork the CE Marking demonstrates that the product complies with the relevant harmonized standard. [7] For steel structures the main harmonized standards are: Steel sections and plate – EN 10025-1; Hollow sections – EN 10219-1 and EN 10210-1; Pre-loadable bolts – EN ...