Search results
Results from the WOW.Com Content Network
In data communications, flow control is the process of managing the rate of data transmission between two nodes to prevent a fast sender from overwhelming a slow receiver. Flow control should be distinguished from congestion control , which is used for controlling the flow of data when congestion has actually occurred. [ 1 ]
The time-stretched and slowed down signal segments are then converted into digital samples by slow electronic ADCs. Finally, these samples are collected by a digital signal processor (DSP) and rearranged in a manner such that output data is the digital representation of the original analog signal.
While a transmitted DSSS signal occupies a wider bandwidth than the direct modulation of the original signal would require, its spectrum can be restricted by conventional pulse-shape filtering. If an undesired transmitter transmits on the same channel but with a different spreading sequence, the despreading process reduces the power of that signal.
Antenna used for transmission of radio signals In telecommunications , transmission (sometimes abbreviated as "TX") is the process of sending or propagating an analog or digital signal via a medium that is wired , wireless , or fiber-optic .
In wireless communications, channel state information (CSI) is the known channel properties of a communication link.This information describes how a signal propagates from the transmitter to the receiver and represents the combined effect of, for example, scattering, fading, and power decay with distance.
This can reduce wasted capacity caused by underutilized reservations at the cost of removing bandwidth guarantees. In practice, congestion control is generally used in IP networks to dynamically negotiate capacity between connections. Packet switching may also increase the robustness of networks in the face of failures.
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires, optical fibers, wireless communication using radio spectrum, storage media and computer buses.
Techniques known since the 1940s and used in military communication systems since the 1950s "spread" a radio signal over a wide frequency range several magnitudes higher than minimum requirement. The core principle of spread spectrum is the use of noise-like carrier waves, and, as the name implies, bandwidths much wider than that required for ...