enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...

3. List of welding codes - Wikipedia

   en.wikipedia.org/wiki/List_of_welding_codes

   Welding - Studs and ceramic ferrules for arc stud welding: ISO 13919-1: Welding - Electron and laser-beam welded joints - Guidance on quality level for imperfections - Part 1: Steel ISO 13919-2: Welding - Electron and laser-beam welded joints - Guidance on quality level for imperfections - Part 2: Aluminium and its weldable alloys ISO 13920

4. A36 steel - Wikipedia

   en.wikipedia.org/wiki/A36_steel

   A36 is readily welded by all welding processes. As a result, the most common welding methods for A36 are the cheapest and easiest: shielded metal arc welding (SMAW, or stick welding), gas metal arc welding (GMAW, or MIG welding), and oxyacetylene welding. A36 steel is also commonly bolted and riveted in structural applications. High-strength ...

5. Bar stock - Wikipedia

   en.wikipedia.org/wiki/Bar_stock

   Drill rod diameters range from 0.0135 to 1.5 in (0.34 to 38.10 mm); in the United States diameters smaller than 27 ⁄ 64 th of an inch (11 mm) are made in letter drill sizes and number drill sizes, in addition to fractional sizes. Lengths are usually one or three feet (0.3048 or 0.9144 m).

6. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.

7. List of welding processes - Wikipedia

   en.wikipedia.org/wiki/List_of_welding_processes

   This is a list of welding processes, separated into their respective categories. The associated N reference numbers (second column) are specified in ISO 4063 (in the European Union published as EN ISO 4063 ). [ 1 ]