Search results
Results from the WOW.Com Content Network
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the network uses the same gateway. The gateway should have a static address, as changing the address would cause packets not to be delivered. The gateway is typically assigned either the highest or lowest network ...
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
Address of a local computer: 192.168.1.100; If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [d] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It ...
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
The protocol establishes an association between gateways in order to achieve default gateway failover if the primary gateway becomes inaccessible. HSRP gateways send multicast hello messages to other gateways to notify them of their priorities (which gateway is preferred) and current status ( active or standby ).
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The original DARPA Internet Protocol's RFC describes [1]: §1.4 TTL as: . The Time to Live is an indication of an upper bound on the lifetime of an internet datagram.It is set by the sender of the datagram and reduced at the points along the route where it is processed.