Search results
Results from the WOW.Com Content Network
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
A slide rule scale is a line with graduated markings inscribed along the length of a slide rule used for mathematical calculations. The earliest such device had a single logarithmic scale for performing multiplication and division, but soon an improved technique was developed which involved two such scales sliding alongside each other.
The calculator described above was called "Model No. 1" . [6] Model 2 had scales on the inner cylinder for calculating logs and sines.The "Fuller-Bakewell" model 3 had two scales of angles printed on the inner cylinder to calculate cosine² and sine ⋅ cosine [note 1] for use by engineers and surveyors for tacheometry calculations.
An architect's scale. A scale ruler is a scaled, three-edged ruler which has six different scales marked to its sides. A typical combination for building details is 1:20, 1:50, 1:100, 1:25, 1:75 and 1:125. There are separate rulers for zoning work as well as for inch units. Today scale rulers are made of plastic, formerly they were made of ...
For example, aligning the rightmost 1 on the C scale with 2 on the LL2 scale, 3 on the C scale lines up with 8 on the LL3 scale. To extract a cube root using a slide rule with only C/D and A/B scales, align 1 on the B cursor with the base number on the A scale (taking care as always to distinguish between the lower and upper halves of the A scale).
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
Following the patent and release of Harold's Long Scale calculator featuring two knobs on the outside rim in 1914, he designed the Magnum Long Scale calculator in 1927. [ 6 ] [ 7 ] As the name "Magnum" implies, it was a fairly large device at 4.5 inches in diameter—about 1.5 inches more than Fowler's average non-Magnum-series calculators. [ 8 ]
The most common and convenient arrangement was to have one of the rulers slide within a groove made along the middle of the other, like an ordinary linear slide rule, as shown in the figure below. Another form had one ruler sliding alongside the other, and a third form had a common two-foot folding ruler with a groove along one side in which a ...