enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   Ring shank: small directional rings on the shank to prevent the nail from working back out once driven in; common in drywall, flooring, and pole barn nails Shank : the body the length of the nail between the head and the point; may be smooth, or may have rings or spirals for greater holding power

3. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.

4. Nail gun - Wikipedia

   en.wikipedia.org/wiki/Nail_gun

   The largest sizes of conventional collated fastenings are the clipped head and full head nails which are used in framing, fencing and other forms of structural and exterior work. These nails generally have a shank diameter of 0.11 to 0.13 in (2.8 to 3.3 mm) although some manufacturers offer smaller diameter nails as well.

5. HurriQuake - Wikipedia

   en.wikipedia.org/wiki/HurriQuake

   To compensate for the extra width of the nail hole, due to the ring shanks, Sutt decided to add a thicker screw-shank to the portion of the nail directly under the head. This addition thickened the top portion of the nail giving it a tighter joint, as well as enhancing its overall holding power. [7]

6. Cement board - Wikipedia

   en.wikipedia.org/wiki/Cement_board

   Typically they range in size from 30 by 48 inches (76 cm × 122 cm) to 36 by 60 inches (91 cm × 152 cm). They are, as one would expect, considerably heavier than the gypsum core type panels. Portland cement based panels are ideal for truly wet locations like shower surrounds and for locations where a Portland cement based thin-set material is ...

7. Barrel threads - Wikipedia

   en.wikipedia.org/wiki/Barrel_threads

   The shank length is not always the same at the thread length, which is the case if the insert has a threadless portion (sub-shank) Tenon designates the thread length; Shoulder designates the barrel diameter in front of the thread portion; Unless otherwise mentioned, right hand threads are assumed. Left hand threads are designated "LH".

8. Rivet - Wikipedia

   en.wikipedia.org/wiki/Rivet

   The most common machine is the impact riveter and the most common use of semi-tubular rivets is in lighting, brakes, ladders, binders, HVAC duct-work, mechanical products, and electronics. They are offered from 1/16-inch (1.6 mm) to 3/8-inch (9.5 mm) in diameter (other sizes are considered highly special) and can be up to 8 inches (203 mm) long.

9. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A 14 mm shank similar to SDS-plus, designed for hammers from 2 to 5 kg. The grip area is increased to 212 mm 2 (0.329 sq in) and the shank is inserted 70 mm. This size remained uncommon and was discontinued in 2009. [5] SDS-max An 18 mm shank with three open grooves and locking segments rather than balls. It is designed for hammers over 5 kg.