Search results
Results from the WOW.Com Content Network
diagram of a double-effect falling film evaporator. Condensing vapors from flash tank B1 heat evaporator A2. •1=feed •2=product •3=steam •4=vapors. In chemical engineering, a multiple-effect evaporator is an apparatus for efficiently using the heat from steam to evaporate water. [1]
The heat that was added in the heater makes up for this loss. [citation needed] The heat added in the brine heater usually comes in the form of hot steam from an industrial process co-located with the desalination plant. The steam is allowed to condense against tubes carrying the brine (similar to the stages). [citation needed] The energy that ...
Multiple effect evaporation (MEE) Thermal vapor recompression (TVR) (also known as thermocompression) A combination of the three methods may be used depending on the process. For instance, a 3-effect evaporator circuit may be installed using MVR to transfer heat.
There are several design variations that are commonly used in industrial field. These include single-effect and multiple-effect evaporators. The choice of evaporator design is dictated by constraints of the process. Fundamentally, there are four factors involved in designing this evaporator: prevention of nucleate boiling; short residence time;
Schematic of a multiple effect desalination plant. The first stage is at the top. Pink areas are vapor, lighter blue areas are liquid feed water. Stronger turquoise is condensate. It is not shown how feed water enters other stages than the first. F - feed water in. S - heating steam in. C - heating steam out. W - Fresh water (condensate) out.
An evaporator is a type of heat exchanger device that facilitates evaporation by utilizing conductive and convective heat transfer, which provides the necessary thermal energy for phase transition from liquid to vapour. Within evaporators, a circulating liquid is exposed to an atmospheric or reduced pressure environment causing it to boil at a ...
A two evaporator single compressor with individual expansion valves for each evaporator after passing through the back pressure valve enters into the compressors and hence there is a significant rise in temperature is observed. This system helps in dropping the pressure from high pressure evaporators with the help of back pressure valves.
Any evaporation system includes a vacuum pump. It also includes an energy source that evaporates the material to be deposited. Many different energy sources exist: In the thermal method, metal material (in the form of wire, pellets, shot) is fed onto heated semimetal (ceramic) evaporators known as "boats" due to their shape. A pool of melted ...