enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fast Ethernet - Wikipedia

   en.wikipedia.org/wiki/Fast_Ethernet

   A Fast Ethernet adapter can be logically divided into a media access controller (MAC), which deals with the higher-level issues of medium availability, and a physical layer interface . The MAC is typically linked to the PHY by a four-bit 25 MHz synchronous parallel interface known as a media-independent interface (MII), or by a two-bit 50 MHz ...

3. 10BASE2 - Wikipedia

   en.wikipedia.org/wiki/10BASE2

   10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.

4. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only ...

5. TV aerial plug - Wikipedia

   en.wikipedia.org/wiki/TV_aerial_plug

   Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.

6. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...

7. F connector - Wikipedia

   en.wikipedia.org/wiki/F_connector

   The F connector was invented by Eric E. Winston in the early 1950s while working for Jerrold Electronics on their development of cable television. [1] In the 1970s, it became commonplace on VHF, and later UHF, television antenna connections in the United States, as coaxial cables replaced twin-lead. It is now specified in IEC 61169-24:2019. [2]