Search results
Results from the WOW.Com Content Network
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
Vehicle dynamics is the study of vehicle motion, e.g., how a vehicle's forward movement changes in response to driver inputs, propulsion system outputs, ambient conditions, air/surface/water conditions, etc. Vehicle dynamics is a part of engineering primarily based on classical mechanics.
Automotive aerodynamics is the study of the aerodynamics of road vehicles. Its main goals are reducing drag and wind noise, minimizing noise emission, and preventing undesired lift forces and other causes of aerodynamic instability at high speeds.
Ixion engine on a Komet motorised bicycle, ca. 1902. This system is used, for example, to drive the spools in some tape recorders.In a typical configuration, one of the cylinders is the axle of an electric motor, say 1 mm in diameter, while the other is a disk with a hard rubber rim, say 50 mm in diameter, yielding a 1:50 mechanical advantage.
For empty freight cars with axle loads of 5.5 tonnes, Crr goes up to 0.00020 at 60 km/h but at a low speed of 20 km/h it increases to 0.00024 and at a high speed (for freight trains) of 120 km/h it is 0.00028. The Crr obtained above is added to the Crr of the other components to obtain the total Crr for the wheels.
Traction (mechanics), adhesive friction or force; Traction vector, in mechanics, the force per unit area on a surface, including normal and shear components; Traction motor, an electric motor used for propulsion of a vehicle, for example a car or a locomotive; Railway electric traction, the use of electric motors to propel rail cars
Traction boards (also called recovery boards) are one of the best ways to free your car when it's stuck in snow, mud, sand, or any other slippery situation. Don't Go Off-Roading Without A Set Of ...
Later American Motors Rambler models (1962 through 1966) used a flange and cushion mount in place of the ball and socket. [5] Since the torque tube does not constrain the car's body to the axle in the lateral (side-to-side) direction, a panhard rod is often used for this purpose. The combination of the panhard rod and the torque tube allows the ...