Search results
Results from the WOW.Com Content Network
Conversely, when pH = pK a, the concentration of HA is equal to the concentration of A −. The buffer region extends over the approximate range pK a ± 2. Buffering is weak outside the range pK a ± 1. At pH ≤ pK a − 2 the substance is said to be fully protonated and at pH ≥ pK a + 2 it is fully dissociated (deprotonated).
The Henderson–Hasselbalch equation can be used to estimate the pH of a buffer solution by approximating the actual concentration ratio as the ratio of the analytical concentrations of the acid and of a salt, MA. The equation can also be applied to bases by specifying the protonated form of the base as the acid.
The smaller the difference, the more the overlap. In the case of citric acid, the overlap is extensive and solutions of citric acid are buffered over the whole range of pH 2.5 to 7.5. Calculation of the pH with a polyprotic acid requires a speciation calculation to be performed. In the case of citric acid, this entails the solution of the two ...
The pH meter is usually calibrated with buffer solutions at known pH values before starting the titration. The ionic strength can be kept constant by judicious choice of acid and base. For instance, HCl titrated with NaOH of approximately the same concentration will replace H + with an ion (Na + ) of the same charge at the same concentration ...
Secondly, the pH (at equilibrium) can be calculated from an individual buffer system regardless of other buffers present. That is, in vivo, knowing the concentration of pCO 2 (weak acid) and bicarbonate (conjugate base) and the pKa of that buffer system, the pH can be calculated regardless of the presence of other contributing buffers.
Borate concentration (giving buffering capacity) can vary from 10 mM to 100 mM. As BBS is used to emulate physiological conditions (as in animal or human body), the pH value is slightly alkaline, ranging from 8.0 to 9.0. NaCl gives the isotonic (mostly used 150 mM NaCl corresponds to physiological conditions: 0.9% NaCl) salt concentration.
Besides the set of parameters obtained by Pitzer et al. in the 1970s mentioned in the previous section. Kim and Frederick [19] [20] published the Pitzer parameters for 304 single salts in aqueous solutions at 298.15 K, extended the model to the concentration range up to the saturation point. Those parameters are widely used, however, many ...
The pH after the equivalence point depends on the concentration of the conjugate base of the weak acid and the strong base of the titrant. However, the base of the titrant is stronger than the conjugate base of the acid. Therefore, the pH in this region is controlled by the strong base. As such the pH can be found using the following: [1]