Search results
Results from the WOW.Com Content Network
This is called a limited calibration. But if the final measurement requires 10% accuracy, then the 3% gauge never can be better than 3.3:1. Then perhaps adjusting the calibration tolerance for the gauge would be a better solution. If the calibration is performed at 100 units, the 1% standard would actually be anywhere between 99 and 101 units.
Fluke Corporation is an American manufacturer of industrial test, measurement, and diagnostic equipment, including electronic test equipment. It was started in 1948 by John Fluke while he was employed at General Electric .
This fluid dynamics –related article is a stub. You can help Wikipedia by expanding it.
The requirements of a flicker measurement equipment are defined in the international electro-technical standard IEC 61000-4-15. [2]A flickermeter is composed of several function blocks which simulate a 230 V/60 W or a 120 V/60 W incandescent lamp (reference lamp) and the human perception system (eye-brain model).
The TDR method is a transmission line technique, and determines apparent permittivity (Ka) from the travel time of an electromagnetic wave that propagates along a transmission line, usually two or more parallel metal rods embedded in soil or sediment. The probes are typically between 10 and 30 cm long and connected to the TDR via coaxial cable.
Power transmission engineering also has great safety concerns due to the high voltages used; although voltmeters may in principle be similar to their low voltage equivalents, safety and calibration issues make them very different. [109] Many disciplines of electrical engineering use tests specific to their discipline.
A time-domain reflectometer; an instrument used to locate the position of faults on lines from the time taken for a reflected wave to return from the discontinuity.. A signal travelling along an electrical transmission line will be partly, or wholly, reflected back in the opposite direction when the travelling signal encounters a discontinuity in the characteristic impedance of the line, or if ...
A mass flow meter of the Coriolis type. A mass flow meter, also known as an inertial flow meter, is a device that measures mass flow rate of a fluid traveling through a tube. The mass flow rate is the mass of the fluid traveling past a fixed point per unit time.