Search results
Results from the WOW.Com Content Network
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...
As previously noted, less wood is needed to produce a given finished size than when standards called for the green lumber to be the full nominal dimension. However, even the dimensions for finished lumber of a given nominal size have changed over time. In 1910, a typical finished 1-inch (25 mm) board was 13 ⁄ 16 in (21 mm). In 1928, that was ...
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada.It equals the volume of a board that is one foot (30.5 cm) in length, one foot (30.5 cm) in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters.
In the United States, planks can be any length and are generally a minimum of 2×8 (1 + 1 ⁄ 2 in × 7 + 1 ⁄ 4 in or 38 mm × 184 mm), but planks that are 2×10 (1 + 1 ⁄ 2 in × 9 + 1 ⁄ 4 in or 38 mm × 235 mm) and 2×12 (1 + 1 ⁄ 2 in × 11 + 1 ⁄ 4 in or 38 mm × 286 mm) are more commonly stocked by lumber retailers.
Typical dimensions of today's "two by four" is 1.5 by 3.5 inches (38 mm × 89 mm) dimensional lumber prior to sanding and are typically placed 16 inches (406 mm) from each other's center, but sometimes also at 12 inches (305 mm) or 24 inches (610 mm).
Quarter-sawn boards have greater stability of form and size with less cupping (compared to flatsawn boards), shrinkage across the width, shake and splitting, and other good qualities. [1] In some woods such as oak , the wood grain produces a decorative effect which shows a prominent ray fleck, while sapele is likely to produce a ribbon figure .
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The most common dimension is 1.2 by 2.4 metres (3 ft 11 in × 7 ft 10 in) or the slightly larger imperial dimension of 4 feet × 8 feet. Plies vary in thickness from 1.4 mm to 4.3 mm. The number of plies—which is always odd—depends on the thickness and grade of the sheet. Roofing can use the thinner 16-millimetre (5 ⁄ 8 in) plywood.