Search results
Results from the WOW.Com Content Network
The Fuller calculator, sometimes called Fuller's cylindrical slide rule, is a cylindrical slide rule with a helical main scale taking 50 turns around the cylinder. This creates an instrument of considerable precision – it is equivalent to a traditional slide rule 25.40 metres (1,000 inches) long.
An architect's scale is a specialized ruler designed to facilitate the drafting and measuring of architectural drawings, such as floor plans and Multi-view orthographic projections. Because the scale of such drawings is often smaller than life-size, an architect's scale features multiple units of length and proportional length increments.
An architect's scale. A scale ruler is a scaled, three-edged ruler which has six different scales marked to its sides. A typical combination for building details is 1:20, 1:50, 1:100, 1:25, 1:75 and 1:125. There are separate rulers for zoning work as well as for inch units. Today scale rulers are made of plastic, formerly they were made of ...
Screwfix Direct Limited, trading as Screwfix, is a retailer of trade tools, accessories and hardware products based in the United Kingdom. [6] Founded in 1979 as the Woodscrew Supply Company, the company was acquired in July 1999 by Kingfisher plc , which also owns B&Q , and is listed on the London Stock Exchange .
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
Only when a full ten marks are counted, is there alignment, because the tenth mark is 10/10—a whole main scale unit—short, and therefore aligns with the ninth mark on the main scale. (In simple words, each VSD = 0.9 MSD, so each decrement of length 0.1 adds 10 times to make one MSD only in 9 divisions of vernier scale division).
For example, aligning the rightmost 1 on the C scale with 2 on the LL2 scale, 3 on the C scale lines up with 8 on the LL3 scale. To extract a cube root using a slide rule with only C/D and A/B scales, align 1 on the B cursor with the base number on the A scale (taking care as always to distinguish between the lower and upper halves of the A scale).
A rolling ruler is a ruler that contains a cylinder much like a rolling pin inside, thereby enabling it to "roll" along a sheet of paper or other surface where it is being used. A rolling ruler can draw straight, parallel lines, and also has other instruments included, enabling it to do the jobs of a protractor and compass .