enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Host controller interface (USB, Firewire) - Wikipedia

    en.wikipedia.org/wiki/Host_controller_interface...

    Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.

  3. IEEE 1394 - Wikipedia

    en.wikipedia.org/wiki/IEEE_1394

    While both technologies provide similar end results, there are fundamental differences between USB and FireWire. USB requires the presence of a host controller, typically a PC, which connects point to point with the USB device. This allows for simpler (and lower-cost) peripherals, at the cost of lowered functionality of the bus.

  4. List of interface bit rates - Wikipedia

    en.wikipedia.org/wiki/List_of_interface_bit_rates

    Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.

  5. Hard disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Hard_disk_drive_interface

    That requires that data be transmitted serially. A similar differential signaling system is used in RS485, LocalTalk, USB, FireWire, and differential SCSI. Serial Attached SCSI (SAS). The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA.

  6. USB - Wikipedia

    en.wikipedia.org/wiki/USB

    The host controller directs traffic flow to devices, so no USB device can transfer any data on the bus without an explicit request from the host controller. In USB 2.0, the host controller polls the bus for traffic, usually in a round-robin fashion. The throughput of each USB port is determined by the slower speed of either the USB port or the ...

  7. USB communications - Wikipedia

    en.wikipedia.org/wiki/USB_communications

    Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts ...

  8. Say Goodbye to Input Lag With These Tried-and-True Xbox ... - AOL

    www.aol.com/goodbye-input-lag-tried-true...

    This Xbox controller is comfortable and ergonomic, and features a 3.5mm stereo headset jack, just like the Xbox Core controller. The included 10-foot USB cable is detachable, making it easy to store.

  9. Extensible Host Controller Interface - Wikipedia

    en.wikipedia.org/wiki/Extensible_Host_Controller...

    For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.