enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Wall hydrant, same as "hosebibb". Tap generally refers to a keg or barrel tap, though also commonly refers to a faucet that supplies either hot or cold water and not both. [citation needed] It also appears as a descriptor in "tap water" (i.e. water purified for domestic use). A single temperature tap is commonly found in a commercial or public ...

3. Sink - Wikipedia

   en.wikipedia.org/wiki/Sink

   Sink. A sink is a bowl-shaped plumbing fixture for washing hands (also known as washbasin in the UK), dishwashing, and other purposes. Sinks have a tap (faucet) that supplies hot and cold water and may include a spray feature to be used for faster rinsing. They also include a drain to remove used water; this drain may itself include a strainer ...

4. Chicago Faucet - Wikipedia

   en.wikipedia.org/wiki/Chicago_Faucet

   The Chicago Faucet Company, founded on the near-west side of Chicago, Illinois, United States, has been producing faucets and other plumbing fixtures since 1901. [4] The company founder, Albert C. Brown, invented the Quaturn Cartridge in 1913 that worked with the flow of water to make it both easy to open and close the spigots and forestalled leak development.

5. Bidet - Wikipedia

   en.wikipedia.org/wiki/Bidet

   Bidet. A bidet (US: / bɪˈdeɪ / ⓘ or UK: / ˈbiːdeɪ /) is a bowl or receptacle designed to be sat upon in order to wash a person's genitalia, perineum, inner buttocks, and anus. The modern variety has a plumbed-in water supply and a drainage opening, and is thus a plumbing fixture subject to local hygiene regulations.

6. Flush toilet - Wikipedia

   en.wikipedia.org/wiki/Flush_toilet

   If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   A tap is used to cut or form the female portion of the mating pair (e.g. a nut). A die is used to cut or form the male portion of the mating pair (e.g. a bolt). The process of cutting or forming threads using a tap is called tapping, whereas the process using a die is called threading. Both tools can be used to clean up a thread, which is ...