enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. 2.5GBASE-T and 5GBASE-T - Wikipedia

   en.wikipedia.org/wiki/2.5GBASE-T_and_5GBASE-T

   Therefore, there was demand for an intermediate standard that could uplink the 2 Gbit/s and 4 Gbit/s speeds from wireless access points over existing Cat5e cable. The development of the 2.5GBASE-T and 5GBASE-T standards enabled wireless access points to reach their maximum speeds without being limited by the Ethernet uplink speeds over a single ...

3. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   A keystone module for a CAT5 network cable A 3-port keystone wall plate. A keystone module is a standardized snap-in package for mounting a variety of low-voltage electrical jacks or optical connectors into a keystone wall plate, face plate, surface-mount box, or a patch panel.

4. Power over Ethernet - Wikipedia

   en.wikipedia.org/wiki/Power_over_Ethernet

   In mode A, pins 1 and 2 (pair 3 in T568A wiring, pair 2 in T568B) form one side of the 48 V DC, and pins 3 and 6 (pair 2 in T568A, pair 3 in T568B) form the other side. These are the same two pairs used for data transmission in 10BASE-T and 100BASE-TX, allowing the provision of both power and data over only two pairs in such networks.

5. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   Cross section of a cat 5e cable. The Category 5e specification improves upon the Category 5 specification by further mitigating crosstalk. [9] The bandwidth (100 MHz) and physical construction are the same between the two, [10] and most Cat 5 cables actually happen to meet Cat 5e specifications even though they are not certified as such. [11]

6. Gigabit Ethernet - Wikipedia

   en.wikipedia.org/wiki/Gigabit_Ethernet

   Supermicro AOC-SGP-I2 dual-port Gigabit Ethernet NIC, a PCI Express ×4 card. 1000BASE-T (also known as IEEE 802.3ab) is a standard for Gigabit Ethernet over twisted-pair wiring. Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and ...

7. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...