enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   For example, DN20 is the size for copper pipe with an outside diameter of 19.05 mm or 3 ⁄ 4 inch. While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a ...

3. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Tube flaring is a type of forging operation, [1] and is usually a cold working procedure. During assembly, a flare nut is used to secure the flared tubing's tapered end to the also tapered fitting, producing a pressure-resistant, leak-tight seal. Flared connections offer a high degree of long-term reliability and for this reason are often used ...

4. Mueller Industries - Wikipedia

   en.wikipedia.org/wiki/Mueller_Industries

   The Plumbing & Refrigeration segment offers copper tubes in straight lengths and coils; copper and plastic fittings, line sets, plastic pipes, valves, and related components for use in water distribution systems, heating systems, air-conditioning, and refrigeration applications, as well as for drainage, waste, and vent systems.

5. Internally grooved copper tube - Wikipedia

   en.wikipedia.org/wiki/Internally_grooved_copper_tube

   Tube weight was reduced by 31% when copper tube diameters were downsized from 3/8 inch to 7 mm. Tube weight was reduced by 46% when copper tube diameters were downsized from 3/8 inch to 5 mm. The weights of the fin materials in the coils was 3.55 kg for the 9.52 mm coils, 2.61 kg for the 7 mm coils, and 1.55 kg for the 5 mm coils.

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   [1] AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.