Search results
Results from the WOW.Com Content Network
A microstrip antenna array for a satellite television receiver Diagram of the feed structure of a microstrip antenna array. In telecommunication, a microstrip antenna (also known as a printed antenna) usually is an antenna fabricated using photolithographic techniques on a printed circuit board (PCB). [1] It is a kind of internal antenna.
An antenna like effect is achieved by periodic swing of electrons from its capacitive element to the ground plane which behaves like an inductor. The authors further argued that the operation of a dielectric antenna resembles the antenna conceived by Marconi, the only difference is that inductive element is replaced by the dielectric material. [5]
The ESR is a derived quantity representing the loss due to both the dielectric's conduction electrons and the bound dipole relaxation phenomena mentioned above. In a dielectric, one of the conduction electrons or the dipole relaxation typically dominates loss in a particular dielectric and manufacturing method. For the case of the conduction ...
Occasionally the phrase antenna effect is used in this context, [7] but this is less common since there are many effects, [8] and the phrase does not make clear which is meant. Figure 1(a) shows a side view of a typical net in an integrated circuit. Each net will include at least one driver, which must contain a source or drain diffusion (in ...
Although no real antenna can be exactly isotropic, a few antennas are built to be as near to isotropic as possible; they are used for emergency backup antennas and for test equipment for other antennas: Because the received and transmitted signal strength is the same in (almost) every direction, they work without any need for them to be any ...
Cross-section of microstrip geometry. Conductor A is separated from ground plane D by dielectric substrate C.Upper dielectric B is typically air.. Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by a dielectric layer known as substrate.
Since monopole antennas rely on a conductive surface, they may be mounted with a ground plane to approximate the effect of being mounted on the Earth's surface. Diagram of the electric fields (blue) and magnetic fields (red) radiated by a dipole antenna (black rods) during transmission. More complex antennas increase the directivity of the antenna.
Slotted array UHF television broadcasting antenna. As shown by H. G. Booker in 1946, from Babinet's principle in optics a slot in a metal plate or waveguide has the same radiation pattern as a driven rod antenna whose rod is the same shape as the slot, with the exception that the electric field and magnetic field directions are interchanged; the antenna is a magnetic dipole instead of an ...