enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Harmonic damper - Wikipedia

   en.wikipedia.org/wiki/Harmonic_damper

   Harmonic balancer lower pulley on a four-cylinder engine. A harmonic damper is a device fitted to the free (accessory drive) end of the crankshaft of an internal combustion engine to counter torsional and resonance vibrations from the crankshaft. This device must be an interference fit to the crankshaft in order to operate in an effective ...

3. Tuned mass damper - Wikipedia

   en.wikipedia.org/wiki/Tuned_mass_damper

   Tuned mass dampers are widely used in production cars, typically on the crankshaft pulley to control torsional vibration and, more rarely, the bending modes of the crankshaft. They are also used on the driveline for gearwhine, and elsewhere for other noises or vibrations on the exhaust, body, suspension or anywhere else.

4. List of Subaru engines - Wikipedia

   en.wikipedia.org/wiki/List_of_Subaru_engines

   For the first time in a Subaru engine, the centerlines of the cylinder bores do not intersect with the crankshaft axis to reduce friction during the piston downstroke; instead, there is a crank offset of 8 mm (0.31 in). Overall thermal efficiency is 40% due to the adoption of lean-burn combustion with an excess air ratio (λ) of 2. [32]

5. Subaru EJ engine - Wikipedia

   en.wikipedia.org/wiki/Subaru_EJ_engine

   The Subaru EJ engine is a series of four-stroke automotive engines manufactured by Subaru. They were introduced in 1989, intended to succeed the previous Subaru EA engine . The EJ series was the mainstay of Subaru's engine line, with all engines of this series being 16-valve horizontal flat-fours , with configurations available for single, or ...

6. Oldsmobile V8 engine - Wikipedia

   en.wikipedia.org/wiki/Oldsmobile_V8_engine

   The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.

7. Underdrive pulleys - Wikipedia

   en.wikipedia.org/wiki/Underdrive_pulleys

   Underdrive pulleys increase engine output by reducing the draw of the engine's accessories by slowing them down and reducing the horsepower (HP) they use. Horsepower gains from underdrive pulleys can vary by vehicle, engine, number of accessories and the amount of underdrive (improvements of up to 5–15 HP at the wheels have been seen).