Search results
Results from the WOW.Com Content Network
A line drawing showing some basic concepts of speeds and feeds in the context of lathe work. The angular velocity of the workpiece (rev/min) is called the "spindle speed" by machinists. Its tangential linear equivalent at the workpiece surface (m/min or sfm) is called the "cutting speed", "surface speed", or simply the "speed" by machinists.
A machinist calculator is a hand-held calculator programmed with built-in formulas making it easy and quick for machinists to establish speeds, feeds and time without guesswork or conversion charts. Formulas may include revolutions per minute (RPM), surface feet per minute (SFM), inches per minute (IPM), feed per tooth (FPT).
Incorrect speeds and feeds will cause damage to the tool, machine spindle, and even the product. The quickest and simplest way to find these numbers would be to use a calculator that can be found online. A formula can also be used to calculate the proper speeds and feeds for a material. These values can be found online or in Machinery's Handbook.
Making a shipboard manhole cover in the machine shop of the aircraft carrier USS John C. Stennis. Relative motion is required between the tool and work to perform a machining operation. The primary action is at a specific cutting speed. In addition, the device must be moved laterally across the work. This is a much slower motion called the feed.
SFM is a combination of diameter and the velocity of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.
These multi-component forces are measured as an individual component force in each co-ordinate, depending on the coordinate system used. The forces during machining are dependent on depth of cut, feed rate, cutting speed, tool material and geometry, material of the work piece and other factors such as use of lubrication/cooling during machining.
It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall. If the value is larger than 1 it is called a trumpet. Depending on the material being cut, feed rate and other factors, a cutting tool with the optimum K factor should be used.
The tool will then feed perpendicularly across the part's rotational axis as it spins in the jaws of the chuck. A user will have the option to hand feed the machine while facing, or use the power feed option. For a smoother surface, using the power feed option is optimal due to a constant feed rate. Facing will take the work piece down to its ...