enow.com Web Search

  1. Ads

    related to: 3.5 x 5 envelope size standard

Search results

  1. Results from the WOW.Com Content Network
  2. ISO 216 - Wikipedia

    en.wikipedia.org/wiki/ISO_216

    The standard defines the "A", "B" and "C" series of paper sizes, which includes the A4, the most commonly available paper size worldwide. Two supplementary standards, ISO 217 and ISO 269 , define related paper sizes; the ISO 269 " C " series is commonly listed alongside the A and B sizes.

  3. Paper size - Wikipedia

    en.wikipedia.org/wiki/Paper_size

    The three-by-five 三五判 (3×5 or 3/5), where the final size at 32K is slightly less than 3 by 5 sun, often given as 84 × 148 mm which would be c. 2.8 × 4.9 sun. The 4/6 standard has given rise to newer metric book-size standards, including:

  4. Floppy disk - Wikipedia

    en.wikipedia.org/wiki/Floppy_disk

    Floppy disk size is often referred to in inches, even in countries using metric and though the size is defined in metric. The ANSI specification of 3½-inch disks is entitled in part "90 mm (3.5-inch)" though 90 mm is closer to 3.54 inches. [48] Formatted capacities are generally set in terms of kilobytes and megabytes.

  5. Photo print sizes - Wikipedia

    en.wikipedia.org/wiki/Photo_print_sizes

    The alternative Super series, denoted SnR, nR Plus or nR+, has an aspect ratio of 3∶2 (or as close as possible) and thus provides a better fit for standard 135 film (35 mm) at sizes of 8 inches or above. 5R is twice the size of a 2R print, 6R twice the size of a 4R print and S8R twice the size of 6R. 4D/6D is a newer size for most consumer ...

  6. List of disk drive form factors - Wikipedia

    en.wikipedia.org/wiki/List_of_disk_drive_form...

    8-, 5.25-, 3.5-, 2.5-, 1.8- and 1-inch HDDs, together with a ruler to show the length of platters and read-write heads A newer 2.5-inch (63.5 mm) 6,495 MB HDD compared to an older 5.25-inch full-height 110 MB HDD. IBM's first hard drive, the IBM 350, used a stack of fifty 24-inch platters and was of a size comparable to two large refrigerators.

  7. Preferred number - Wikipedia

    en.wikipedia.org/wiki/Preferred_number

    The √ 2 factor also appears between the standard pen thicknesses for technical drawings in ISO 9175-1: 0.13, 0.18, 0.25, 0.35, 0.50, 0.70, 1.00, 1.40, and 2.00 mm. This way, the right pen size is available to continue a drawing that has been magnified to a different standard paper size.

  1. Ads

    related to: 3.5 x 5 envelope size standard