enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

4. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

5. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   The pipe end should be square so it sits against the stop in the fitting and does not cause turbulence in the flow of water. It is quite easy to push the pipe in only as far as the grab ring, or the O-ring, and not all the way to the stop. This is the most common issue with inexperienced use of these connectors.

6. Rain gutter - Wikipedia

   en.wikipedia.org/wiki/Rain_gutter

   The down pipe can terminate in a shoe and discharge directly onto the surface, but using modern construction techniques would be connected through an inspection chamber to a drain that led to a surface water drain or soakaway. Alternatively it would connect via a storm drain with 50 mm water seal to a combined drain. [19]

7. Leader head - Wikipedia

   en.wikipedia.org/wiki/Leader_Head

   Copper Leader Head at Penn's Quadrangle, Philadelphia 1894 Copper Leader at Shofuso Japanese House and Garden in Philadelphia. The purpose of a leader head is to help transfer excess water from the roof onto downspouts, thus preventing the gutters from overflowing and water washing over the walls, which is a common occurrence in areas susceptible to heavy rain cycles.

8. Downspout - Wikipedia

   en.wikipedia.org/wiki/Downspout

   Downspouts are usually vertical and usually extend down to ground level, although may be routed at an angle to avoid architectural features and may discharge onto an intermediate roof. At the bottom of downspout there are typically features to divert discharged water away from the building's foundations to prevent water damage.

9. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   A close nipple can only be unscrewed by gripping one threaded end with a pipe wrench which will damage the threads and necessitate replacing the nipple, or by using a specialty tool known as a nipple wrench (or known as an internal pipe wrench) which grips the inside of the pipe, leaving the threads undamaged. When the ends are of two different ...