Search results
Results from the WOW.Com Content Network
Hoist atop an elevator. A hoist is a device used for lifting or lowering a load by means of a drum or lift-wheel around which rope or chain wraps. It may be manually operated, electrically or pneumatically driven and may use chain, fiber or wire rope as its lifting medium.
An overhead crane, featuring runways, bridge, and hoist in a traditional industrial environment. Overhead crane at the Skanska precast concrete factory in Hjärup, Sweden. Gantry-style overhead cranes of the Hainaut quarry in Soignies, Belgium. An overhead crane, commonly called a bridge crane, is a type of crane found in
The generic term used by the International Union of Railways for the technology is overhead line. [1] It is known variously as overhead catenary, overhead contact line (OCL), overhead contact system (OCS), overhead equipment (OHE), overhead line equipment (OLE or OHLE), overhead lines (OHL), overhead wiring (OHW), traction wire, and trolley wire.
EOT cranes are extensively used in warehouses and industry. [2] An EOT crane is able to carry heavy objects to anywhere needed on the factory floor, and can also be used for lifting. However, it cannot be used in every industry. The working temperature is to limited to a range between -20°C to 40°C. [citation needed]
Contact between a pantograph and an overhead line is usually assured through a block of graphite. This material conducts electricity while working as a lubricant. As graphite is brittle, pieces can break off during operation. Poorly-built pantographs can seize the overhead wire and tear it down, and poor-condition wires can damage the pantograph.
Raw materials are poured into a furnace by crane, hot steel is stored for cooling by an overhead crane, the finished coils are lifted and loaded onto trucks and trains by overhead crane, and the fabricator or stamper uses an overhead crane to handle the steel in his factory. The automobile industry uses overhead cranes for handling of raw ...
Four wool spinning machines driven by belts from an overhead lineshaft (Leipzig, Germany, circa 1925) The belt drives of the Mueller Mill, model and reality, in motionA line shaft is a power-driven rotating shaft for power transmission that was used extensively from the Industrial Revolution until the early 20th century.
Transmission tower in Toronto, ON Single-circuit three-phase transmission line Transmission towers on a hill field. Three-phase electric power systems are used for high voltage (66- or 69-kV and above) and extra-high voltage (110- or 115-kV and above; most often 138- or 230-kV and above in contemporary systems) AC transmission lines.