enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).

4. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   US Tap and Drill Bit Size and Reference Chart [7] Machine Screw Size Number of Threads Per Inch (TPI) Major Diameter Minor Diameter Tap drills Clearance Drill 75% Thread for Aluminum, Brass, & Plastics 50% Thread for Steel, Stainless, & Iron Close Fit Free Fit Drill Size Decimal Equiv. Drill Size Decimal Equiv. Drill Size Decimal Equiv. Drill ...

5. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...

6. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

7. Talk:List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/Talk:List_of_drill_and_tap...

   The two columns after the screw/tap size indicate the size of drill to use to drill holes that the screw can fit through closely or with a bit of slack; but the drill sizes have been converted to their decimal-inch equivalents which isn't useful. This should be fixed. I believe I can come up with a better organization of columns; I'll think ...