enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Knot density - Wikipedia

   en.wikipedia.org/wiki/Knot_density

   Knot density is a traditional measure for quality of handmade or knotted pile carpets. It refers to the number of knots, or knot count, per unit of surface area - typically either per square inch (kpsi) or per square centimeter (kpsc), but also per decimeter or meter (kpsd or kpsm). Number of knots per unit area is directly proportional to the ...

3. Square foot - Wikipedia

   en.wikipedia.org/wiki/Square_foot

   Comparison of 1 square foot with some Imperial and metric units of area. The square foot (pl. square feet; abbreviated sq ft, sf, or ft 2; also denoted by ' 2 and ⏍) is an imperial unit and U.S. customary unit (non-SI, non-metric) of area, used mainly in the United States and partially in Canada, the United Kingdom, Bangladesh, India, Nepal, Pakistan, Ghana, Liberia, Malaysia, Myanmar ...

4. Floor area - Wikipedia

   en.wikipedia.org/wiki/Floor_area

   Hong Kong law Chapter 123F, Building (Planning) Regulations, Regulation 23 sect 3 sub-paragraph (a) defined that: Subject to sub-paragraph (b), for the purposes of regulations 19, 20, 21 and 22, the gross floor area of a building shall be the area contained within the external walls of the building measured at each floor level (including any floor below the level of the ground), together with ...

5. Floor area ratio - Wikipedia

   en.wikipedia.org/wiki/Floor_area_ratio

   For example, if a lot must adhere to a 0.1 FAR, then the total area of all floors in all buildings on the lot must be no more than one-tenth the area of the parcel itself. In other words, if the lot was 10,000 sq. ft, then the total floor area of all floors in all buildings must not exceed 1,000 sq. ft.

6. List of unusual units of measurement - Wikipedia

   en.wikipedia.org/wiki/List_of_unusual_units_of...

   A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...

7. Square (unit) - Wikipedia

   en.wikipedia.org/wiki/Square_(unit)

   Construction in Australia no longer uses the square as a unit of measure, and it has been replaced by the square metre. The measurement was often used by estate agents to make the building sound larger as the measure includes the areas outside under the eaves, and so cannot be directly compared to the internal floor area.