enow.com Web Search

  1. Ads

    related to: difference between ide and sata cables

Search results

  1. Results from the WOW.Com Content Network
  2. Hard disk drive interface - Wikipedia

    en.wikipedia.org/wiki/Hard_disk_drive_interface

    Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data. [a] An additional cable was used for power, initially frequently AC but later usually connected directly to a DC power supply unit. The controller provided ...

  3. Parallel ATA - Wikipedia

    en.wikipedia.org/wiki/Parallel_ATA

    As a result, many near-synonyms for ATA/ATAPI and its previous incarnations are still in common informal use, in particular Extended IDE (EIDE) and Ultra ATA (UATA). After the introduction of SATA in 2003, the original ATA was renamed to Parallel ATA, or PATA for short. Parallel ATA cables have a maximum allowable length of 18 in (457 mm).

  4. SATA - Wikipedia

    en.wikipedia.org/wiki/SATA

    A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...

  5. Hard disk drive - Wikipedia

    en.wikipedia.org/wiki/Hard_disk_drive

    Integrated Drive Electronics (IDE), later standardized under the name AT Attachment (ATA, with the alias PATA (Parallel ATA) retroactively added upon introduction of SATA) moved the HDD controller from the interface card to the disk drive. This helped to standardize the host/controller interface, reduce the programming complexity in the host ...

  6. Advanced Host Controller Interface - Wikipedia

    en.wikipedia.org/wiki/Advanced_Host_Controller...

    When a SATA controller is configured to operate in IDE Mode, the number of storage devices per controller is usually limited to four (two IDE channels, master device and slave device with up to two devices per channel), compared to the maximum of 32 devices/ports when configured in AHCI mode.

  7. An IHOP server fed a man facing homelessness. She says she ...

    www.aol.com/ihop-server-fed-man-facing-203159367...

    Victoria Hughes says she was fired from IHOP after feeding a man who was hungry. She has since been offered her job back.

  1. Ads

    related to: difference between ide and sata cables