enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

3. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...

4. Threaded insert - Wikipedia

   en.wikipedia.org/wiki/Threaded_insert

   TIME-SERT insert. A threaded insert, also known as a threaded bushing, is a fastener element that is inserted into an object to add a threaded hole. [1] They may be used to repair a stripped threaded hole, provide a durable threaded hole in a soft material, place a thread on a material too thin to accept it, mold or cast threads into a work piece thereby eliminating a machining operation, or ...

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Hyperboloid contacts are designed to withstand more extreme physical demands, such as vibration and shock. [20] They also require around 40% less insertion force [25] – as low as 0.3 newtons (1 oz f) per contact, [26] – which extends the lifespan, and in some cases offers an alternative to zero insertion force connectors. [27] [25]

6. Insert nut - Wikipedia

   en.wikipedia.org/wiki/Insert_nut

   The screw-in insert nuts come in various sizes and take different screw sizes. For example, an M6 insert nut will take an M6 bolt, a "1/4-20" insert nut will take a 1/4-20 inch bolt., etc The pre-drilled hole must be as deep as the length of the insert nut plus any portion of the bolt that may be screwed past the end of the nut in the work piece.

7. Safety wire - Wikipedia

   en.wikipedia.org/wiki/Safety_wire

   A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...