Search results
Results from the WOW.Com Content Network
In fact, for many systems a linear approximation is good enough. One can also note that the monopulse ratio is continuous within the null-to-null beam width, but has asymptotes that occur at the beam nulls. Therefore, the monopulse ratio is only accurate to measure the deviation angle of a target within the main lobe of the system.
In a distribution, full width at half maximum (FWHM) is the difference between the two values of the independent variable at which the dependent variable is equal to half of its maximum value. In other words, it is the width of a spectrum curve measured between those points on the y -axis which are half the maximum amplitude.
Chainline on a fixed-gear bicycle. The chainline is the angle of a bicycle chain relative to the centerline of the bicycle frame. [1] A bicycle is said to have a perfect chainline if the chain is parallel to the centerline of the frame, which means that the rear sprocket is directly behind the front chainring. [1]
The observer would first use this device to measure the angular width of the target. Knowing the angular width of the target, the range to the target, and the known length of that ship class, the angle on the bow of the target can be computed using equations shown in Figure 2. Human observers were required to determine the angle on the bow.
The amount of additional material removed when making the gears depends on the pressure angle of the teeth. For a 14.5° pressure angle the extra distance the cutting tool is moved in equals the amount of backlash desired. For a 20° pressure angle the distance equals 0.73 times the amount of backlash desired. [3]
In numerical analysis, order of accuracy quantifies the rate of convergence of a numerical approximation of a differential equation to the exact solution. Consider u {\displaystyle u} , the exact solution to a differential equation in an appropriate normed space ( V , | | | | ) {\displaystyle (V,||\ ||)} .
For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation of 0.036 mm) and the hole might be specified with a tolerance range from 10.04 mm to 10.076 mm (0.04 mm fundamental ...
Five definitions of the beam width are in common use: D4σ, 10/90 or 20/80 knife-edge, 1/e 2, FWHM, and D86. The beam width can be measured in units of length at a particular plane perpendicular to the beam axis, but it can also refer to the angular width, which is the angle subtended by the beam at the source.