enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for cable ...

3. USB-C - Wikipedia

   en.wikipedia.org/wiki/USB-C

   USB-C plug USB-C (SuperSpeed USB 5Gbps) receptacle on a laptop. USB-C, or USB Type-C, is a 24-pin, reversible connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, to connect to monitors, external drives, hubs/docking stations, mobile phones, and many more peripheral devices.

4. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   USB bridge cables, or data transfer cables can be found within the market, offering direct PC to PC connections. A bridge cable is a special cable with a chip and active electronics in the middle of the cable.

5. USB communications - Wikipedia

   en.wikipedia.org/wiki/USB_communications

   The half-duplex lines are still used for configuration. SuperSpeed+ (SS+) uses increased signaling rate (Gen 2×1 mode) and/or the additional lane in the Type-C connector (Gen 1×2 and Gen 2×2 mode). A USB connection is always between a host or hub at the A connector end, and a device or hub's upstream port at the other end.

6. USB On-The-Go - Wikipedia

   en.wikipedia.org/wiki/USB_On-The-Go

   USB OTG defines two roles for devices: OTG A-device and OTG B-device, specifying which side supplies power to the link, and which initially is the host. The OTG A-device is a power supplier, and an OTG B-device is a power consumer. In the default link configuration, the A-device acts as a USB host with the B-device acting as a USB peripheral ...

7. USB4 - Wikipedia

   en.wikipedia.org/wiki/USB4

   A USB and DP certification service lists USB Gen 1 cables ("5 Gbps") as supporting UHBR10 speeds, which would fit for having the same requirements as USB4 "20 Gbps" connections. [ 51 ] Anandtech reports [ 52 ] that "this also means that DP Alt Mode 2.0 should largely work with USB4-compliant cables, although VESA is being careful to avoid ...