enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   A hex key (also, hex wrench, Allen key and Allen wrench or Inbus) is a simple driver for bolts or screws that have heads with internal hexagonal recesses ().. Hex keys are formed from a single piece of hard hexagonal steel rod, having blunt ends that fit snugly into similarly shaped screw sockets.

3. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Acorn nut (cap nut) Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut A nut that has a domed end on one side Barrel nut: Steel cross dowel or dowel nut, cross dowel (woodworking) A round slug or formed sheet metal part with threads perpendicular to the length of the nut Cage nut: Caged nut, captive nut, clip nut

4. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

5. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Below are some common spanner sizes for metric screw threads. Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have ...

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

7. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   A self-aligning nut, also known as a spherical nut [2] or leveling nut, is a type of nut used in applications where the fastener is not perpendicular to the surface to which the nut anchors. A flange nut is used inside a specially shaped dished-out washer. The device is commonly used in the aerospace industry.