enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

3. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   A second connector that goes to the motherboard (in addition to the 24-pin ATX motherboard connector) to supply dedicated power for the processor. 4+4-pin For the purpose of backwards compatibility, some connectors designed for high-end motherboards and processors, more power is required, therefore EPS12V has an 8-pin connector.

4. PS-ON Signal - Wikipedia

   en.wikipedia.org/wiki/PS-ON_Signal

   #PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).

5. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).

6. Berg connector - Wikipedia

   en.wikipedia.org/wiki/Berg_connector

   Many types of Berg connectors exist. Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in ...

7. AT (form factor) - Wikipedia

   en.wikipedia.org/wiki/AT_(form_factor)

   Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...

8. 16-pin 12VHPWR connector - Wikipedia

   en.wikipedia.org/wiki/16-Pin_12vHPWR_connector

   The 16-pin 12VHPWR connector is a standard for connecting graphics processing units (GPUs) to computer power supplies for up to 600 W power delivery. It was introduced by Nvidia in 2022 to supersede the previous 6- and 8-pin power connectors for GPUs. The stated aim was to cater to the increasing power requirements of Nvidia GPUs.

9. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   Modern, ATX supplies, by contrast, are capable of being switched on and off by the computer itself, and the power button is actually a signal that is received by the motherboard and in turn passed along to the power supply. This allows the motherboard to remove power upon shutdown (with the exception of the aforementioned 5V standby power ...